Skip to main content
Version: 3.1

How To Attach a YubiHSM Hard Wallet

Goal​

Attach a YubiHSM as a hard wallet

Before you begin​

  • Install the currently supported version of keosd

  • Install YubiHSM2 Software Toolkit (YubiHSM2 SDK)

  • Create an AuthKey with at least the following Capabilities:

    • sign-ecdsa
    • generate-asymmetric-key
    • export-wrapped

  • Delete the default AuthKey

Security

It is extremely important to create a new AuthKey and remove the default AuthKey before proceed to the following steps.

Steps​

Configure keosd​

There are two options to connect keosd to YubiHSM:

Using a YubiHSM connector​

By default, keosd will connect to the YubiHSM connector on the default host and port. If a non-default URL is used, set the --yubihsm-url option or yubihsm-url in config.ini with the correct connector URL

Directly connect via USB​

keosd also can directly connect to YubiHSM via USB protocol

If this option is used, set keosd startup option as the below:

--yubihsm-url=ysb://

Start keosd with AuthKey:​

--yubihsm-authkey Your_AuthKey_Object_Number

if a YubiHSM connector is used, check the YubiHSM connector is up and running by visiting YubiHSM URL: http://YubiHSM_HOST:YubiHSM_PORT/connector/status ((Default HOST and Port: http://127.0.0.1:12345)

You should see something like this:

status=OK
serial=*
version=2.0.0
pid=666
address=localhost
port=12345

Unlock YubiHSM wallet with the password of AuthKey using the following option:​

cleos wallet unlock -n YubiHSM --password YOUR_AUTHKEY_PASSWORD

After unlocking the wallet, you can use cleos wallet commands as usual. Beware as a part of security mechanism, some wallet subcommands, such as retrieve private keys, or remove a key, are not supported when a YubiHSM is used